Serving Doral, Sweetwater, Miami Springs, Westchester, Kendall, Coral Gables & western Miami-DadeCall (786) 699-6948
Impact Windows in Doral, FL

Single hung, casement, roller and picture windows

Impact Windows in Doral, FL

Full-frame replacement with laminated glass, approved for Miami-Dade's High-Velocity Hurricane Zone.

  • Free in-home measurement and an itemized written estimate for every opening
  • Products listed with their Miami-Dade NOA or Florida Product Approval number
  • Permit filed and inspections scheduled with the city or county before and during the work

Replacing Windows With Impact Glass

Impact windows use laminated glass: two or more layers of glass bonded to a tough plastic interlayer. When something hits the pane, the glass may crack, but the interlayer holds the pieces in the frame and the opening stays closed. That matters because once a window fails in a storm, wind enters the house and pushes up on the roof from inside. In Doral, every replacement window must carry approval for the High-Velocity Hurricane Zone, so the frame, glass and anchoring are tested as one system.

Signs it is time

  • Original aluminum awning, jalousie or single-pane sliding windows from the 1980s or 1990s
  • Fogging between panes, rattling sashes, or water showing at the sill after afternoon storms
  • Panels or shutters you no longer want to put up each season
  • An insurer or wind mitigation inspector noting unprotected openings
  • Street, highway or airport noise you want to cut down

Get a Free Estimate

Frames and glass

Most impact windows here use aluminum or vinyl frames. Aluminum is slim and strong and handles large sizes well. Vinyl insulates better and is often a little less expensive. The glass package matters as much as the frame: a laminated unit can be paired with a second insulating pane, low-E coatings to cut heat gain, and tints from light gray to bronze. Ask what design pressure each unit is rated for. Corner and upper-story openings on a taller building usually need a higher rating than a ground-floor window in the middle of a wall.

What the install involves

We remove the old window, check the wood or concrete buck around the opening, and repair or replace it if it is rotten or cracked. The new unit is set, shimmed and fastened with the screw type, spacing and edge distance printed in its approval. The City of Doral's buck and fastener inspection checks those details before the opening is closed up. Then the perimeter is sealed, stucco is patched outside and trim is finished inside. Labels stay on the glass until the final inspection is signed off.

Choosing styles room by room

Bedrooms need an egress opening, so a casement or single hung window with enough clear opening size usually goes there. Living areas facing a lake or golf course often get large fixed picture windows. Horizontal rollers suit wide, short openings over kitchen counters. We note the style for each opening on the estimate, so you can see where the price differences come from.

Window Types We Install

Every style below is available with Miami-Dade HVHZ approval in a range of sizes.

Single hung

The bottom sash slides up, the top stays fixed. A common, cost-effective choice for bedrooms that need egress.

Casement

Hinged on one side and opened with a crank, it seals tightly when closed and gives a full clear opening for egress.

Horizontal roller

One sash slides sideways. Good for wide, low openings and spots where an outward-swinging sash would hit a walkway or patio furniture.

Fixed and picture windows

Non-operable glass for large views. With no moving parts, they can be made in big sizes at a lower price per square foot.

Mulled combinations

Several units joined with a structural mullion, such as a picture window flanked by casements. The mullion itself must carry its own product approval.

Specialty shapes

Arches, half-rounds and transoms over doors, made to match an existing opening.

Impact Sliding Glass Doors in Doral, FL

Typical Impact Window Costs

JobTypical range
Small casement window, about 24 x 24 in. (installed)$700 to $800
Medium double-hung window, about 36 x 60 in. (installed)About $1,800
One impact window, vinyl to fiberglass frame$700 to $2,875
Installation labor per window$100 to $600
Ten-window home$7,000 to $28,750
Twenty-window home$14,000 to $57,500

National ranges from published cost guides. Ranges vary with opening size, frame material, glass package, design pressure, buck repairs and the number of openings. Your written estimate is the price.

How an Impact Window Job Runs

1. Measure and assess

We measure every opening, check the buck and wall type, and mark which rooms need egress windows.

2. Written estimate

Each opening is priced with the product, its approval number, glass options and finish work listed.

3. Permit and order

We file the permit package and order custom-sized units once the product approvals are accepted.

4. Install and inspect

Old windows out, bucks repaired, new units anchored per the approval, then the buck and fastener inspection.

5. Finish and final

Stucco, caulk and trim are completed, and the final inspection closes the permit.

Impact French Doors in Doral, FL

Impact Windows Questions

Can impact glass break?

Yes, the outer pane can crack when struck. The laminated interlayer is designed to hold the pieces in place so the opening stays closed. A cracked unit should be replaced afterward.

Do impact windows help with noise?

The laminated interlayer dampens sound, so most owners notice less traffic and aircraft noise. Units with an added insulating pane typically reduce it further.

Can you replace just a few windows?

Yes. Each opening is priced separately, so you can do the most exposed sides first. Keep in mind that insurance credits for opening protection usually require every opening to be protected.

What frame color options are there?

White and bronze are the most common, with other colors depending on the product line. If you live in a condo or HOA, check the association's hurricane protection specifications before choosing.

How do I check a window's approval?

Ask for the Miami-Dade NOA or Florida Product Approval number for each product. Both are public, and the document lists the tested pressures, sizes and anchoring method.

Get a Impact Windows Estimate

Free measurement and a written price for each window.

Call Now: (786) 699-6948